SS-6R - Assembly Instructions

To assemble your Six Monitor Synergy Stand please follow these steps:

Step 1 - Base & Central Pole Installation

(Components: SS-B1, SS-BP, SS-P2)

Step 2 - Lower Central Clamp Installation

(Component: SS-C1)

Installation Tip 1: Install the lower central clamp before attaching the lower central monitor to enable perfect screen alignment.

Installation Tip 2: Do not attach the upper central clamp until you have installed the lower central screen as this sits between the two central clamps on your central pole.

Step 3 - Lower JOINING & End Arm Installation

(Components: SS-A1, SS-A2)

Installation Tip: Attach the bottom set of arms only during this step.

Step 4 - Lower CENTRAL SCREEN & VESA Mount Installation

(Component: SS-C2)

Installation Tip: Let the monitor hang below the clamp and slide down into position directly over the lower SS-C1 clamp.

Step 5 - Lower OUTER SCREEN & VESA Mount Installation

(Component: SS-V1)

Installation Tip: Tighten the clamp screws equally to ensure the best grip and to avoid damage to your clamp.

Step 6 - Upper CENTRAL CLAMP INSTALLATION

(Component: SS-C2)

Step 7 - Upper JOINING & End Arm Installation

(Components: SS-A1, SS-A2)

Installation Tip: Attach the upper set of arms during this step.

Step 8 - Upper CENTRAL SCREEN & VESA Mount Installation

(Component: SS-C2)

Installation Tip: Let the monitor hang below the clamp and slide down into position directly over the upper SS-C1 clamp.

Step 9 - Upper OUTER SCREEN & VESA Mount Installation

(Component: SS-V1)

Installation Tip: Tighten the clamp screws equally to ensure the best grip and to avoid damage to your clamp.

Download Assembly Instructions (PDF) - Assembly Instructions